Rev: 12.28.22 Page 11 CCD-0004051
Stabilizer Guide Track Bracket
Install the stabilizer guide track brackets (Fig. 18A) as close as possible to the side of the bed to avoid
a tip-over when under load.
NOTE: The stabilizer guide track bracket (Fig. 18A) locations may vary per bed.
1. Place the stabilizer guide track bracket (Fig. 18A) on the end rail frame, as close as possible to the side
of the bed frame.
2. Use a 4.0 mm (5/32 in) drill bit to pre-drill the side hole (Fig. 18B).
3. Install a 4.2 mm x 13mm screw (Fig. 18B) in the side hole of the stabilizer guide track bracket.
4. Use a 4.0 mm (5/32 in) drill bit to pre-drill the top of the end rail hole (Fig. 19A).
5. Install a 4.2 mm x 13 mm screw with a #5 washer into the belt bracket top hole (Fig. 19A) closest to the
edge of the outside rail.
6. Repeat steps 1-5 for the other stabilizer guide track bracket.
Mounting Channel Brackets
1. Insert the shorter, motor mounting channel bracket (Fig. 20A), into the end rail channel closest
to where the motor will be placed. Tip the topside up into the channel and then slide the motor
mounting bracket down into the bottom of the end rail channel.
2. Place one mounting channel bracket (Fig. 21A) into the side rail channel, closest to where the motor
will be placed. Tip the topside of the mounting channel bracket up into the top of the side rail channel
and then slide the mounting channel bracket down into the bottom of the side rail channel.
3. Repeat step 2 for the opposite side of the Smart Bed.
Fig. 18
Fig. 19
A
B
A
Fig. 20
Fig. 21
A
A
To Next Page
Loading...
