Rev: 12.28.22 Page 20 CCD-0004051
Belt Mounting Brackets
1. Remove the tape holding the belts in the rolled-up position on the drive shaft.
2. Feed the short belts into the closest end rail belt brackets (Fig. 38A) and feed the long belts into the
opposite end rail belt brackets (Fig. 39A).
3. Locate the belt mounting assembly (Fig. 40). Unscrew the nuts (Fig. 41A) and slide the belt plates
(Fig. 41B) off the belt bracket (Fig. 41C) and set aside. Do this for all four belt brackets.
4. If installing on a unit with aluminum backing in the wall, use a minimum size of #10 x 1.00" self-drilling
screws. If installing on a unit with wood backing in the wall, use a minimum size of #10 x 1.00" wood
screws.
5. Place the bottom side of the bed frame down on level supporting saw horses at the approximate fully
retracted position. Make sure the bed frame is level.
Fig. 38 Fig. 39
Fig. 40 Fig. 41
A
A
A
B
B
C
To Next Page
Loading...
