Lippert SMART BED UNIVERSAL KIT - Drive Shaft Header Assembly

Rev: 12.28.22 Page 14 CCD-0004051
Drive Shaft Header Assembly
The drive shaft header assembly will be installed on one side of the short drive shaft (Fig. 27) and one side
of the long drive shaft (Fig. 28). Make sure that the header is installed on the correct side of the drive shafts
prior to installing on the bed frame. This step is imperative as the belts will not function correctly if the drive
shaft is improperly installed.
Long Belt
Short Belt Short Belt
Long Belt
Fig. 27
Fig. 28
A
B
C
D
F
G
H
Short
Drive Shaft
E
Fig. 29
1. Place the drive shaft end plate (Fig. 29H) on the correct end of the drive shaft and secure with
two #8-15 x 1.00" Phillips pan head steel sheet metal screws (Fig. 29G) with a clutched screw gun.
Torque to 14 ft-lbs.
2. Coat the threaded part of the M6 screw (Fig. 29A) with high strength red Loctite® and apply
Super Lube® grease to the end of the bolt.
3. Insert the M6 hex head screw (Fig. 29A) through the M6 wave washer (Fig. 29B), the zinc fender washer
(Fig. 29D), the o-ring (Fig. 29D), and the centering bracket (Fig. 29E).
4. Coat the inside of the bushing (Fig. 29F) with Super Lube® grease, then install it onto the end of the
assembled M6 hex head screw (Fig. 29A).
Correct End for Short Drive Shaft Header Installation Correct End for Long Drive Shaft Header Installation