Rev: 12.28.22 Page 13 CCD-0004051
5. Install a pin strap fastener (Fig. 24B) into the loop end of the long belt (Fig. 24A).
6. With the pin strap legs facing down towards the bottom of the drive shaft, and the seam of the belt
facing out away from the drive shaft, thread the pin strap fastener with the long belt installed into the
short drive shaft channel on the left side of the drive shaft.
7. Locate the long drive shaft, position the end of the shaft so the internal keyway is positioned
up (Fig. 25A).
8. Install a pin strap fastener (Fig. 25C) into the loop end of the short belt (Fig. 25B).
9. With the pin legs facing up towards the top of the drive shaft, and the seam of the belt facing out away
from the drive shaft, thread the pin strap fastener with the short belt installed, into the drive shaft
channel on the left side of the drive shaft (Fig. 25).
10. Install a pin strap fastener (Fig. 26A) into the loop end of the long belt (Fig. 26B).
11. With the pin legs facing down towards the bottom of the drive shaft, and the seam of the belt facing
out away from the drive shaft, thread the pin strap fastener with the long belt installed, into the drive
shaft channel on the right side of the drive shaft.
B
A
C
A
B
A
B
12. Roll the belts on the drive shafts and tape the ends so they do not unroll until instructed to insert the
belts into the belt bracket.
Fig. 24
Fig. 25 Fig. 26
To Next Page
Loading...
