Rev: 12.28.22 Page 7 CCD-0004051
Slat Brackets and Wood Slats
NOTE: Wood slats will be cut to length for different bed sizes. Refer to model print for quantity.
1. Locate a left and a right slat bracket (Fig. 10A). With the insert tabs facing down, insert three wood slats
(Fig. 10B) with their curved side facing up, into the slat brackets.
2. Place the assembled brackets into the side rail insert channels with the bracket tabs (Fig. 10A) facing
down.
NOTE: The slat bracket assemblies should rest in the insert channels of the side rails and the center rail
support (Fig. 11) until all the slat bracket assemblies are in place.
A
Fig. 10 Fig. 11
A
B
3. During slat bracket assembly installation, make sure the end of one slat bracket (Fig. 12A) is seated to
the beginning of the next slat bracket assembly's tab (Fig. 12B).
Fig. 12
A
B
B
To Next Page
Loading...
