Lippert SMART BED UNIVERSAL KIT - Operation Switch; Wiring Harness Connections; Wire Harness to Components

Rev: 12.28.22 Page 24 CCD-0004051
Operation Switch
NOTE: If installing on a unit with aluminum backing in the wall, use a minimum size of #10 x 1.00" self-drilling
screws. If installing on a unit with wood backing in the wall, use a minimum size of #10 x 1.00" wood screws.
The operation switch can be installed in the wall of the unit next to the bed frame or if installing padded rails
to the bed frame, in the padded rails.
1. Cut into the wall or the side panel of the bed an area 3" x 2" x 1" for the switch plate to be installed.
2. Install two #10 x 1/2" screws one screw on each side of the switch plate (Fig. 51A).
Wiring Harness Connections
Wire Harness to Components
1. Install the main wire harness power controller's connector (Fig. 52B) to the power controller's male
connector (Fig. 52A).
2. Install the main wire harness ACS (Advanced Control System) connector (Fig. 52E) to the ACS module
connector (Fig. 52C). The connecting wire colors are white, yellow, orange and green.
NOTE: The ACS module blue and purple wires (Fig. 52D) are only used to set the ACS module when
assembling the components. Disregard these wires for OEM installation.
3. Remove the connector plug (Fig. 52J) from the main wire harness power and directional wires.
This plug is only used when testing the system.
4. Splice the yellow and orange wires (Fig. 52H) to the corresponding yellow and orange wires of the
switch harness non-connector end (Fig. 52G).
5. Splice the red and black wires (Fig. 52I) to the corresponding red and black wires of the switch harness
non-connector end (Fig. 52G). The 20A circuit protection should be wired between the switch and the
main power source or battery (Fig. 52L).
6. Install the switch harness connector end (Fig. 52F) to the back of the switch (Fig. 52K).
7. Install the main wire harness motor connector (Fig. 52M) to the motor's female connector (Fig. 52N).
Fig. 51
AA