Rev: 12.28.22 Page 30 CCD-0004051
Operation
Prior to Operating the Smart Bed Lift System
The Smart Bed Lift system must never be used while the vehicle is in motion.
1. Make sure the vehicle is parked, secured and stabilized before starting operations.
2. Set the parking brake, if applicable.
Lowering the Smart Bed Lift
1. If installed, make sure the safety belts are unfastened.
2. Turn the key switch to the ON position (Fig. 59B) located on the key switch.
3. Press and hold the DOWN arrow-shaped button (Fig. 59D) on the bed switch. The bed will keep
moving until it reaches the pre-set stop position.
NOTE: The bed will stop moving when the button is released. Continue to press and hold the button until
the stop position has been reached.
4. Release the DOWN arrow-shaped button.
5. Turn the key switch to the OFF position (Fig. 59A).
Raising the Smart Bed Lift
1. Turn the key switch to the ON position (Fig. 59B) located on the key switch.
2. Press and hold the UP arrow-shaped button (Fig. 59C) on the key pad. The Smart Bed Lift will keep
moving until it reaches the pre-set stop position.
NOTE: The bed will stop moving when the button is released. Continue to press and hold the button until
the stop position has been reached.
3. Release the UP arrow-shaped button.
4. If installed, make sure the safety belts are fastened.
5. Turn the key switch to the OFF position (Fig. 59A).
Always make sure that the Smart Bed Lift path is clear of people, pets and objects before and during
operation. Always keep away from the slide rails when the bed is being operated. Do not allow
people or pets on bed while it is in motion.
Fig. 59
A
B
C
D
To Next Page
Loading...
