Rev: 12.28.22 Page 2 CCD-0004051
TABLE OF CONTENTS
Introduction 2
Safety 3
Important Safety Information 3
Resources Required 4
Prior to Installation 4
Installation 4
Bed Frame Assembly 4
Center Rail Support 6
Slat Brackets and Wood Slats 7
Belt and Stabilizer Guide Brackets 10
Mounting Channel Brackets 11
Drive Shafts and Belts 12
Drive Shaft Header Assembly 14
Drive Shaft and Motor Installation 15
Motor Mount Support and Bracket 18
Drive Shaft Centering Bracket 18
Belt Mounting Brackets 20
Stabilizer Channel Guides 23
Operation Switch 24
Wiring Harness Connections 24
Wire Harness to Components 24
Wiring Diagram 25
Setting the ACS Stop Procedure 27
Flex Track For Wires 28
Safety Belt Harness 29
Operation 30
Prior to Operating the Smart Bed Lift System 30
Lowering the Smart Bed Lift 30
Raising the Smart Bed Lift 30
Manual Override 31
Maintenance 31
Introduction
The Smart Bed™ Universal Kit distributed by Lippert Components, utilizes a unique nylon strap-based
system, adaptable to a broad range of RV and heavy truck applications including cabs, living rooms, slide-
out rooms and master bedrooms. The straps retract into the bed base, concealing the lifting system in the
retracted position, permitting OEMs more floor plan design freedom. The nearly silent Smart Bed Lift
system is operated by a single motor that controls four support mounts to raise and lower the bed at 58.4
mm (2.3 inches) per second. The 362 Kilogram (800-pound) capacity system can be customized in both size
and configuration to maximize space in any motorhome, towable RV or truck cab floor plan design. The
system can even “bend” to conform to wall curvatures found in some motorhome cabs.
For information on the assembly or individual components of this product, please visit:
https://www.lippertcomponents.eu/support-smart-bed.
NOTE: Images used in this document are for reference only when assembling, installing and/or operating
this product. Actual appearance of provided and/or purchased parts and assemblies may differ.
To Next Page
Loading...
