Lippert SMART BED UNIVERSAL KIT - Drive Shaft and Motor Installation

Rev: 12.28.22 Page 15 CCD-0004051
Drive Shaft and Motor Installation
Refer to (Fig. 30 and Fig. 31) for motor and advanced control system (ACS) parts and assembly orientation.
1. Slide the ACS module holder (Fig. 30A) onto the long drive shaft end (Fig. 30B). Make sure the ACS
module housing (Fig. 30C) faces away from the motor (Fig. 30D).
2. Apply Super Lube® Grease to both ends of the motor shafts (Fig. 30E and Fig. 30F).
3. Make sure motor shaft keys (Fig. 30E and Fig. 30F) are in place prior to long or short shaft installation.
4. Align motor key (Fig. 30F) with long drive shaft keyway, then insert the keyed motor shaft into the end
of the long drive shaft (Fig. 30B).
5. Align the screw holes to the motor mounting bracket (Fig. 30G) along with the angle bracket holes
(Fig. 30H) and the motor holes (Fig. 30I). Install three hex head steel serrated flange bolts (Fig. 30J)
through the two brackets and into the motor.
6. Align motor key with short drive shaft keyway (Fig. 30E) then insert the short drive shaft (Fig. 30K) onto
the motor shaft (Fig. 30E).
7. Align the power controller (Fig. 30L) screw holes with the motor mounting bracket screw holes (Fig. 30M).
8. Make sure the power controller interface is facing towards the motor, then install two #4 x 1/4" Phillips,
Type A, sheet metal screws up through the motor bracket and into the power controller (Fig. 30L).
5. Use a hex key to tighten the M6 screw with assembly onto the drive shaft end plate (Fig. 29H).
NOTE: Make sure the o-ring (Fig. 29D) is not compressed beyond the zinc fender washer (Fig. 29C).
6. Repeat steps 1-5 for the long drive shaft end.
A
B
C
E
F
D
G
I
J
K
L
H
M
N
O
P
Q
Fig. 30