Rev: 12.28.22 Page 31 CCD-0004051
Maintenance
The Smart Bed Lift system has been designed to require very little maintenance. To ensure the long life
of your Smart Bed Lift system, read and follow these few simple procedures:
1. When the bed is raised, visually inspect the slide rail assemblies.
A. Check for excess buildup of dirt or other foreign material.
B. Remove any debris that may be present.
2. If the system squeaks or makes any noises, blow out any debris from the drive shaft and apply a dry
lubricant to prevent and/or stop squeaking.
Manual Override
Always disconnect from power source before performing any operation on the Smart Bed Lift System
To raise or lower the Smart Bed Lift in case of emergency, it is possible to operate the system manually.
1. Insert the provided crank device (Fig. 60A) into the motor (Fig. 60B).
2. Turn clockwise to raise or counterclockwise to lower the bed.
3. Have the Smart Bed Lift serviced by an OEM-authorized dealer as soon as possible. Do not operate the
Smart Bed Lift until service is complete, as damage to the Smart Bed Lift system may result.
A
B
Fig. 60
To Next Page
Loading...
