Lippert SMART BED UNIVERSAL KIT - Center Rail Support

Rev: 12.28.22 Page 6 CCD-0004051
Center Rail Support
1. Measure and mark the center of both end rails (Fig. 1A).
2. Attach the center rail support mounting brackets (Fig. 8A) to both ends of the center rail support
(Fig. 8B) with three #8 - 15 x 1.00" Phillips flat head screws (Fig. 8C).
3. Place the center rail support (Fig. 9A) at the center of the end rails (Fig. 9B) with the wide flat side of the
center support, facing down. Make sure to insert the center rail support into the top channel extrusion of
the end rails (Fig. 9C).
4. Insert the wood slats into place, see Slat Brackets and Wood Slats section.
NOTE: Secure the center rail mounting brackets (Fig. 9D) to the end rail channels only AFTER the wood
slats are completely in place. This ensures the center rail support is properly aligned and gives
sufficient play when hammering in the slat brackets.
5. Attach each end of the center rail support's mounting brackets (Fig. 9D) to the end rail's insert channels
(Fig. 9C) with two 3.9 x 9.5mm screws (Fig. 9E) into each end of the center rail support mounting
bracket and the end rail inner channel.
11. If applicable, bend the bendable flat bracket (Fig. 7A) to the desired angle for each joint assembly.
12. Place the bendable flat bracket centered over the assembled joint and just under the slat and insert
channel (Fig. 7B) on the side rail.
13. Install 12 rivots at each pre-drilled hole (Fig. 7C).
14. If applicable, repeat steps 11-13 for each support joint.
Fig. 7
B
C
A
Fig. 8
B
C
A
C
Fig. 9
A
B
C
D
E
E