Lippert SMART BED UNIVERSAL KIT - Page 5

Rev: 12.28.22 Page 5 CCD-0004051
4. Starting at one end rail, insert a corner cap key (Fig. 2A) into each end of the rail (Fig. 2B).
5. Use a rubber mallet to make sure the corner cap keys are connected tight within the end rail.
NOTE: The end rails should stop at the notched top (Fig. 2C) and bottom edge of the corner cap (Fig. 2D).
6. Repeat step 4 and step 5 for the rest of the corner caps.
7. If the Smart Bed Lift configuration uses angled sides, assemble the joints together (Fig. 3A) and secure
with a bolt (Fig. 3B) and nut (Fig. 3C).
8. Insert the assembled angled joint into the side rails (Fig. 4). The end rails should stop at the notched
center (Fig. 4A).
9. Use a rubber mallet to make sure all the rails are tightly secured onto the corner cap keys and
angled joints.
Fig. 2 Fig. 3
Fig. 4
Fig. 5
A
B
10. To hold the corner cap keys and angled joints in place, install four 3.9 x 9.5mm screws, two on either
end of each rail (Fig. 5A and Fig. 6A).
Fig. 6
C
A
A
A
A
A
A
A
B
C
A
A
A
A
D
A