Rev: 12.28.22 Page 8 CCD-0004051
6. Repeat steps 1-5 on the other side of the center support rail until all slat bracket assemblies have
been installed.
7. Cut the excess slat bracket (Fig. 10B) off the last slat bracket assembly to fit, before it is placed
into the frame.
8. Use a rubber mallet to secure the tabs on the bottom of the slat holders into the side rail insert channel.
A. Smart Beds using a center rail support.
I. Start with the slat brackets on one side of the center support rail at one end.
II. Using a rubber mallet, firmly strike the slat brackets into the side rail channels and the center
rail support channels, alternating between the left and right sides of the bracket.
III. Continue securing the slat brackets from one end to the other.
IV. Make sure the wood slats on either side of the center support rail are aligned (Fig.13).
V. Repeat steps I - IV for the other side.
VI. Secure the center rail support to the end rail channels by inserting two #6 - 18 x 3/8" Phillips
drive pan head screws (Fig. 9E) into each end of the center rail support mounting bracket and
the end rail inner channel (Fig. 9C).
9. Using a pneumatic staple gun, attach the slat bracket holders (Fig. 14A) to the wood slats (Fig. 14B),
on both sides, one staple per wood slat (Fig. 14C).
NOTE: Inspect the bed frame and make sure there are no dents to the frame. Buff out any minor scratches.
3.00"
Fig. 13
A
4. Create an approximate 3" gap from the end rail's insert channel to the first wood slat on both sides of
the center rail support (Fig. 13A).
5. Make sure the wood slats installed on either side of the center rail support are even with each other (Fig. 13).
Fig. 14
C
A
B
To Next Page
Loading...
