Rev: 12.28.22 Page 21 CCD-0004051
100 mm (3
⁄
in)
Minimum Distance
50 mm (1
⁄
in)
Minimum Distance
A
B
C
D
6. With the bed frame supported and at the fully retracted position, measure from the desired belt
mounting bracket position to the bottom of the bed on both sides. The measurement from the
bottom of the belt mounting bracket (Fig. 422A) to the bottom of the bed frame (Fig. 42C) should
be at a minimum of 100 mm (3 15/32 in).
The maximum distance away from the bottom of the belt mounting bracket (Fig. 42A) on the wall
to the edge of the rail of the bed frame (Fig. 42D) is 50 mm (1 31/32 in).
7. Mark the measured locations for the brackets.
NOTE: A prefabricated jig may be used for a faster installation of the belt brackets.
8. Install the belt mounting brackets at the marked locations from step 7, onto wall of the unit with nine
#10 x 1.00" screws.
9. Place the bottom side of the bed frame down on level supporting saw horses at the approximate fully
extended position. Make sure the bed frame is level.
10. Extend one belt up from the bed frame, making sure the belt is not twisted and there is no slack
in the belt.
Fig. 42
To Next Page
Loading...
