Lippert SMART BED UNIVERSAL KIT - Page 19

Rev: 12.28.22 Page 19 CCD-0004051
3. Fasten the motor mounting bracket (Fig. 36A) to the motor mount support adjustable slot
(Fig. 35E) with two 4.2 x 13mm screws (Fig. 36C). Also refer to Figure 31Q for the screw holes
in the mounting bracket.
4. Place the opposite end of the motor mounting bracket (Fig. 37A) onto the motor mounting channel
bracket (Fig. 37B) and install two nuts (Fig. 37C).
NOTE: Tighten the nuts on the drive shaft completely after the motor mount support and motor mount
bracket have been installed.
Fig. 36
A
B
C
Fig. 37
A
B
C
C