20/48
3.5. Electrical voltage
Danger of electric shock
The machine works with high voltages and currents. The user can suffer fatal electric shocks due to
damaged lines or electrical components.
Do no operate the machine with damaged electrical components
Immediately replace defective cables or components
Do not use the machine if it cannot be switched on and off via the switch
Always completely unroll cable drums.
Only connect via power sources with integrated fault current circuit breaker or an RCD
Only connect using cables with PE wires and a suitable wire diameter
Lay cables so they do not pose a tripping hazard and do not lay them in puddles or over sharp
edges
Do not cut into the cable
Always pull the plug before shutting off the machine
To Next Page
Loading...
