33/48
6.6. Relocating the floor saw
Cut hazard at rotating saw blade
When touching the rotating saw blade, clothing and limbs can be pulled in and severed.
The machine may not be maneuvered while the blade is spinning.
During relocation, the operator may not leave the intended working position behind the handle
bars.
Danger in the work zone
When running, the machine poses a high risk of injury if it is not operated and used responsibly and in
accordance with the specifications.
The operator must remain behind the handle bars while cutting.
The floor saw may only be operated by one person; ensure all other personnel vacate the cutting
area, or close off the area.
When interrupting the cutting process, always switch the motor off via the main switch.
Relocating the floor
saw
Completely lift the saw blade out of the kerf using the hand wheel.
Close the water supply valve.
Let the saw blade run until it stops!
Move the floor saw to the desired position.
Align the saw blade with the cutting line and start the machine
To Next Page
Loading...
