LITE-CHECK INSPECTOR 930
24
message for a few moments, and then will automatically
exit the test. The PLC is read through the auxiliary
circuit and will have no faults.
Next the tester will search for the PLC Signal and will
attempt to determine the ECU Manufacturer. This
process may take up to a minute to complete.
Once the PLC is detected, the ECU will be identified.
The ECU manufacturer’s name will display along with other
information including any active faults present in the
system.
NOTE: Each star indicates a stage in the ECU’s
information retrieval. If the tester is unable to complete
identification, note the number of stars and contact LITE-CHECK customer support.
Main Menu
Pressing the SELECT button displays the ABS
Menu.
Use the UP and DOWN buttons to navigate the menu. The cursor ‐> on the
display will move up and down, indicating which option is selected. Press the
SELECT button to choose a menu option. Move the cursor –> to the bottom of the
digital display. Pressing the DOWN button once more will display additional menu
options.
Viewing Active Faults
View active faults by using the DOWN button to get to the
“VIEW ACTIVE FAULT” option. Then press SELECT.
The digital display will show the active faults.
Pressing the DOWN button will display the first active
fault. In this case, an “Open/Short Circuit” is indicated.
Press the DOWN button again to display the next active
fault. Press the UP button to return to the previous fault.
DOWN
SELECT
HELP
UP
To Next Page
Loading...
