LITE-CHECK INSPECTOR 930
27
The help screens will provide you with more information on how to trace and correct the
Fault. Use UP and DOWN arrow buttons to move through the help screens like these.
Press the ABS (BACK) button to return to the
ABS
fault display.
ABS Fault Identification and Troubleshooting
The following table shows the manufacturers and types of ABS supported by the
LITE-CHECK INSPECTOR 930.
1
Exit ABS mode to cycle power and clear faults
All information and directions were obtained directly from each of the above ABS OEMs.
The LITE-CHECK process conforms to each OEM’s procedure.
NOTE: If the INSPECTOR 930 tester does not support a particular ECU, such as an
Eaton unit, the tester display will read “NOT SUPPORTED AT THIS TIME” or “UNABLE
TO DETERMINE ECU TYPE.”
BACK
1
To Next Page
Loading...
