CHAPTER 9: MALFUNCTIONS 9-6
ALPHA 538/552
AL13: Safety time for part feed out elapsed!
Description
This alarm is generated when the bar feeder has
not received any clamping device closing signal
within the determined timeframe (approx. 30s.).
Solutions
Check the presence of the closing signal.
Check the closing of the clamping device.
Check the wiring of the signal A1.
AL14: Part feed out too long!
Description
The part feed out is too long.
Solutions
Check the part length value in parameter P02.
AL15: Part feed out too short!
Description
The part feed out is too short.
Solution
Check if a delay is set on the lathe clamping
device.
To Next Page
Loading...
