CHAPTER 8: OPERATION 8-17
ALPHA 538/552
SERVICE: additional I/O module
Additional outputs for specific functions.
SERVICE: Mode
Working mode
Conventional mode for machining
Simulation
Only for shows. Simulate machining process
without bar stock.
Test interface mode
Cycle to test the interface.
5.9. HELP
To reach the Help menu, press the STOP button, then press "?".
HELP: Software versions
Shows PLC and HMI installed software versions.
HELP: Interface signals
Shows signals and their status.
Grey = not active
Red = active
To Next Page
Loading...
