3.1 Configuring Access
SECTION 3.1
The Default Access Code is
NOTICE
1 2 3 4 5 6
9
How to Use the Keypad
There are a total of five (5) buttons on the keypad as shown in
the example image to the left. The numbers in each button may
differ than what is shown on your device than
what is displayed
here.
To enter your required digit, just simply press the circle where your
number is shown. You do not need to press the actual number
as anywhere within the circle will suffice.
The button on the bottom is the OK button. You will be pressing
this button when you are done entering your Access Code.
OK Button
We recommend pairing your lock to your smart phone to manage your
access
codes. Section 3.1 - 3.9 refers to locks not paired with a smart
phone. Once
paired with a smart phone, the Program button will be
disabled.
Your new Lockly Access Code can be any combination of 6 to 8 digits. Once a new Access Code
is entered, the Default Access Code of 123456 would be deleted. A maximum of 52 sets of Access
Codes can be stored for use at any given time. To add more than 52 sets of Access Codes, you
must delete an existing Access Code before adding a new code.
To Next Page
Loading...
Need help?
General
