2.7 Low Battery
SECTION 2.7
When the battery is in seriously low condition, Lockly will make continuous beeping sounds in addi
tion
to the flashing low battery icon on the touch screen. You should replace batteries immediately
to
avoid your smart lock from shutting down.
When your smart lock low-battery warning alert finally dies, you will have 3 chances to unlock your
smart lock either by a password, APP or fingerprint. If the unlock was successful, the low-battery
warning alert will be on for 1 minute. After which, the smart lock will go to dead battery mode and
will lock auto lock in 5 seconds and the screen will display a low-battery icon.
Dead Battery
Condition Indicator Solution
Low Battery
Battery Icon on the display
keypad will light up to indicate
low
battery . At the same time,
Lockly logo on the interior panel
will flash red to reminder users
that battery is low.
Replace batteries immediately to
avoid battery failure. Lockly Secure
can still operate up to 300 cycles
in low battery condition.
When there is no display
and
sounds; and screen is
non-func-
tional.
Replace batteries immediately.
Supplied physical backup keys
can be used to unlock the door.
Alternatively, use a 9V battery as
shown below to temporarily activate
the lock.
Your Lockly will automatically
detect battery
polarity. So hold your 9V
battery lead in place
against bottom of
the Lockly to temporarily
activate
t
he screen to enter your Access Code.
Be sure to hold the 9V battery against
the
contact points located at the bottom
of the
lock until you have successfully
unlocked your
door with your Access
Code. Once unlocked,
batteries should
be replaced immediately.
7
9V Battery
-
+
To Next Page
Loading...
Need help?
General
