3.4 Deleting an Access Code
SECTION 3.4
While in Programming Mode, select
“2DE” to delete an Access Code.
If you are not in Programming Mode,
please see Section 3.2 to enter
Programming Mode.
After pressing “2DE” press “Pd” to
delete an Access Code.
OK Button
Example Only
Active Access Codes will then be displayed on the screen in
sequence from left to right, top to bottom. In the example shown
on the left, the Access Code displayed is 1 3 5 7 9 0 .
Rotate through different Access Codes shown by touching any
number on the screen. If you find the Access Code you want
to delete, simply hold the OK Button for 3 seconds. (Continue
on next page)
13
To Next Page
Loading...
Need help?
General
