3.3 Adding an Access Code
SECTION 3.3
While in Programming Mode, select
“1AD” to add an Access Code. If you
are not in
Programming Mode, please see
Section 3.2 to enter Programming
Mode.
After pressing “1AD” press “Pd” to
add an Access Code.
11
Enter your new 6 - 8 digit Access Code and press when you
are finished. You will then re-enter the code to confirm your new
Access Code.
Remember, just touch the digit you need within the circle around
each 3 numbers. There is no need to touch the exact location of
the number. For example, based on the example image to the
left, if you need “1”, you can touch the upper left button. For “6”,
you would touch the upper right button.
To Next Page
Loading...
Need help?
General
