3.5 Checking the Access Codes
SECTION 3.5
While in Programming Mode, select “3CH”
to check registered Access Codes. If you
are not in Programming Mode, please see
Section 3.2 to enter Programming Mode.
Active Access Codes will then be displayed
on the screen in sequence from left to right,
top to bottom. In the example shown on
the left, the Access Code displayed is 1 3
5 7 9 0 .
OK Button
Rotate through the different Access Codes by touching any number on the screen.
To exit Check Access Code screen, simply press the OK Button.
If there are no Access Codes registered in your smart lock, Check
Access Code mode will be invalid. The default Access Code will
not be shown on the display keypad, and you will see the following
screen shown to the left instead.
15
To Next Page
Loading...
Need help?
General
