- 34
english
Adjusting the picture
MENU: Call TV menu.
Select Picture,
go to the menu line below.
Select the desired picture function,
go to the menu line below.
Make changes.
Explanations of the picture settings:
You can switch between three fixed picture setting vari-
ants and the three personal picture values that you have
set here (see right hand column).
The contrast setting depends on the brightness of the
room. The brighter the surroundings the higher the
contrast should be set.
The power consumption of the TV set is directly depend-
ent on the value set here (see also page 22).
Set the colour intensity to suit your personal taste. The
colours should appear natural.
Here, you can give the TV picture a warmer or colder hue
according to your personal taste.
Set the brightness so that the black areas of the picture
only just appear black.
Here you can adjust picture sharpness to obtain the best
definition.
With active DNC (Digital Noise Control) you can eliminate
or reduce picture noise.
Call with OK.
Picture improvement on/off and demo mode for Image
+
Active.
Automatic detection and setting of the picture format for
Cinemascope or widescreen movies.
Set picture format (see page 35).
Move picture vertically (see page 35).
Presettings / Personal settings for picture adjustment
MENU: Call TV menu.
Select Picture,
go to the menu line below.
Select Picture adjustment,
go to the menu line below.
Select Presettings or Personal settings.
For presettings, go to the menu line below.
Select the desired presetting for the picture.
OK Confirm selection.
Explanations for Picture adjustment:
If you select Presettings, the picture settings for the signal input group
currently active are set to predefined values. See Glossary for an explana-
tion: Signal input groups.
Your own settings for contrast, colour intensity, colour temperature,
brightness, sharpness and digital noise suppression are saved in the
personal values. At the same time, you have your own personal values
for each signal input group.
All picture and sound adjustments can be reset to the default values in
one step for all signal input groups in the index of the TV set under Reset
picture/sound or
Factory settings picture/sound.
Contrast Colour intensity Colour
To Next Page
Loading...
Need help?
General
