17Carbide Cutter OM
Getting Started
For best results, the areas to be mowed should be free of
debris such as bottles, metal objects, rocks and wire etc.
The teeth cut and pulverize the brush, grass and weeds.
Operate the carbide cutter as low to the ground as
possible without the teeth striking ground or other
obstructions. Because of the high speed of the teeth, the
life of the teeth will be reduced if it is operated in rocky
terrain or in areas where many obstacles are present.
The carbide cutter deposits cut material over the entire
width-of-cut, which eliminates bunching or windrowing
behind the machine.
Operation
Tilt attachment mounting frame back and raise the
carbide cutter slightly above the ground when moving
the carbide cutter and machine.
NOTE: Operate the carbide cutter as low to the ground
as possible without the teeth striking ground or
other obstructions.
Lower the carbide cutter until the skids contact the
ground. Engage the auxiliary hydraulics. Move the loader
and carbide cutter forward and begin mowing.
NOTE: Various mowing conditions, and desired finished
cut appearance, will determine proper ground
speed.
Operating Instructions
WARNING: Due to the potential danger of
flying debris, it is the owner’s responsibility
and is “ABSOLUTELY MANDATORY that
IMPACT-RESISTANT SHIELDING” be
installed on the machine to protect the
operator.
WARNING: Do not operate the attachment
above the rated RPM. Check with your
Loftness dealer to be sure your attachment
is set-up with the correct hydraulic motor to
match the hydraulic flow GPM (Gallons Per
Minute) of your machine.
WARNING: Flying debris can gather on
the skid-steer and needs to be cleaned off,
especially around the radiator and oil cooler
screens, engine compartment and exhaust
areas. Periodic cleaning will help prevent the
possibility of fire.
WARNING: DO NOT allow ANY people or
animals within 300 feet of the work area
while operating this machine.
WARNING: DO NOT allow ANY people or
animals within 300 feet of the work area
while operating this machine.
DANGER: Keep hands and feet out! Do not
step on or climb over the unit while machine
is in operation, or engine is running. Do not
carry passengers.
WARNING: Lifting or tilting the carbide cutter
increases the risk of flying debris.
WARNING: Lifting or tilting the carbide cutter
increases the risk of flying debris.
To Next Page
Loading...