26 Carbide Cutter OM
Troubleshooting
Maintenance
PROBLEM CAUSE SOLUTION
Excessive Vibration Broken or missing teeth. Replace teeth.
Mud and/or debris wrapped around
the rotor.
Clean the carbide cutter.
Faulty drive line bearing. Replace bearing(s).
Faulty rotor bearing. Replace bearing(s).
Damage to rotor (includes bent end
of shafts, missing balance weights,
or actual rotor deformity from striking
rocks, etc.)
Consult factory.
Uneven Cutting Teeth dull or worn excessively. Replace teeth.
Engine RPM too slow. Adjust machine RPM to full throttle.
Travel speed too fast. Reduce ground speed.
Rotor Will Not Turn Faulty drive line bearing. Replace bearing(s).
Faulty rotor bearing. Replace bearing(s).
Belt damaged. Replace belt.
Belt slipping. Clean or replace belt.
Adjust tension.
To Next Page
Loading...