(19) Insert bolts through the
holes along the sides of both the
chain-saw bed (pylon) and the
spool holder plate. Turn the
square nuts a few times. (8x
M6x16 bolts, 8 x M6 square
nuts)
(20) Insert the square nuts into
the slide rail track, moving the
spool holder plate and the
chain-saw bed to opposite ends
of the slide rails. Tighten the
bolts.
Assembly: saw carriage
15
(21) Thread the line spool over
the spool holder arm and tighten
the nut. (1 x M10 locking nut)
20
21
19
To Next Page
