Long 2360 - Guide to Hydraulic Lift Control

IMPEMENT
Moldboard Plows:
-Single-furrow (ona-way or
two-way)
-Two-furrow (ona-way or
two-way)
- Three-furrow
~ I Disc Plows:
-Two-Disc
-Three-Disc
Narrow (blade, tooth or disc type)
Subsoilers
Cultivators (of any type)
D~char
Weeders, Ridgers, ate.
Carried Seed Drills
Soft Nature
{
loose
medium
compact
{
loose
medium
compact
{
loose
medium
compact
1 or 2
2 or 3
3 or 4
2
3
4
}~
4
3
4
3 or 4
3or4
3 or 4
3or4
3 or4
3 or 4
1¥
}draft control
}draft control
} draft control
} draft conUol
draft control
draft control
draft control
draft control
position
position
Upper
Link Anchor
Support Wedge I Guage Wheels
disconnected no
disconnected
no
slack
diconnacted no
slack
disconnected
no
slack
disconnected
no
slack
disconnected no
slack
disconnected
no
slack
disconnected
no
slack
connected
yes
taut
connected yes
taut
Manure Forks, Rear Mounted -
I 3 or 4 I position contrcf connected I yes I taut
Grader Blade, Augers, Scrapers, {
Tansport Boxes, ect.
Mower Bars (side
& rear mounted - I 3 or 4 I position contrcf connected 1 yes I taut
REMARKS
Adjust chains so that the
implement is allowed limited
sideways
(2 - 2 3/8 inches)
When
in the raised position,
the implement must not move
sideways excessively
{
During work, leave the
lift
control lever all the way down
{
If the implement has gauge
wheels, during work leave the
lift control lever all the way
down
CAUTION: Adjust lifter response
sensitiv~y by su~ably setting laver (item 3 -fig. 20- 23). Obtain maximum possible sensitivity
without causing implement jolting or operator discomfort.