Long 2360 - INTRODUCTION, SPECIFICATIONS, AND EQUIPMENT; Tractor Overview and Specifications

INTRODUCTION
LONG has two models of the 2360 tractor. The LONG
2360 and 2360 DTC. These tractors are equipped with
an in-line 3 cylinder diesel rated at 35.5 PTO H.
P. (26.1
Kw).
The 2360 DTC is a 2360 tractor with a front drive axle
(4 wheel drive).
This manual was prepared to furnish you with informa-
tion related to breaking-in, operating and servicing the
tractor. Also included
is information on safety proce-
dures, specifications, maintenance and lubrication in-
structions, accessories and the tractor warranty.
It is strongly recommended that you read this entire
manual carefully prior to operating the tractor for the
first time. This will allow you to become familiar with the
tractor's controls and the break-in period procedures.
The times spent in becoming familiar with the tractor
will be repaid by your efficiency and a longer operating
service life of the tractor.
TRACTOR IDENTIFICATION
The tractor's serial number is located on the identifica-
tion plate, located on the right hand side of the trans-
mission housing as shown in Fig. 1
Fig. 1 -Chassis Serial No.
The tractor's engine serial
number is located on the
identification plate located on the left hand side of the
engine block as shown in Fig. 2
SPECIFICATIONS
ENGINE
PTO Horsepower
................... 35 .5 (26.1 Kw)
Type
.. ...... .. ..... ....... Di rect Injection Diesel
Rated Engine Speed
................... 2400 RPM
Number of Cylinders
......................... 3
Bore
.......................... 3. 7 4 in. (95mm)
Stroke
....................... 4.33 in. (110mm)
Displacement
....... ...... .. 143 Cu. in. (2344 cc)
Cylinder Liner
.......... ...... .. Dry Replaceable
Compression Ratio
... .. .. . ................. 17 :1
Operating Range
............. . .... 600 to 2550 RPM
Firing Order
............................. 1-2-3
5
POWER TRAIN
Clutch Type
............ Dry WI Independent Controls
Clutch Diameter
................ 11 in. (279.4mm)
Transmission Type ...... Sliding Gear/Constant Mesh
Number of Speeds ........... 8 Forward, 2 Reverse
(Synchronized 3rd, 4th, 7th,
& 8th)
Service Brakes
Type
................ Dry Mechanical Band
Actuation
................... Foot Pedals
(Independent for each side w/transport lock)