Long 2360 - Maintenance & Lubrication

After every 250 hours, or more in very wet, muddy
conditions, lubricate the front wheel bearings. There
is
one fitting on each wheel.
MAINTENANCE & LUBRICATION (DTC Tractor)
In addition to the aforementioned maintenance and
lubrications, the following should also be done for the
(DTC) 4-wheel drive tractor.
After every· 60 hours of operation, lubricate the front
axle pivot, and both of the universal joints on the front
drive shaft. There are three fittings. Also, after every 60
hours of service, lubricate the front axle kingpins. (Not
shown). There are four fittings.
Fig. 73- Front Drive Steering Knuckle Pivot
42
Fig. 74- Front Axle Pivot
A. Filler Plug; B. Drain Plug; C. Pivot Pin
Fig. 75 - Universal Joint, Front Drive Axle
After every 120 hours of operation, check the oil level
in the front axle housing. The oil should be level with the
bottom of the filter hole. Add oil as necessary. Refer to
the lubrication guide fro the proper type and quantity of
the oil used.
After every 120 hours of operation, remove the center
plug from the front hubs and check the oil level. The oil
level should be at the bottom of the hole. In a case
where it is low, just add oil as necessary. Refer to the
lubrication guide fro the proper type and quantity of oil.