Lorentz PS200 - 9.6 Electrical Testing Illustrated; Testing Solar Array DC Performance; Battery System Testing Notes

page 50 | v100820 Errors excepted and possible alterations without prior notice. Manual | LORENTZ PS Pump Systems
Installation date
Installer
(full contact details)
Well depth m | ft
Pump depth m | ft
Additional vertical lift (to top of tank) m | ft
Static water level m | ft
Drawdown level m | ft
Drop pipe (vertical from the pump)
Size mm
2
| in
Type
Length m | ft
Additional pipe length (to tank)
Size mm
2
| in
Type
Length m | ft
Submersible pump cable
Wire size mm
2
| AWG
Length (controller to pump) m | ft
Max. RPM control
Factory setting is maximum. yes no
If this setting was reduced,
enter setting here:
System Report13
Date of purchase
Dealer
(full contact details)
System voltage V
Battery system yes no
Quantity of solar modules
Solar module brand
Module model #
Controller model PS1800 PS1200
PS600
PS200
other, i.e.:
Controller serial #
Pump end model #
Pump end serial #
Motor model #
Motor serial #
Temperature Range
Helical rotor pumps (without “C” in the model number) work optimally only in a specific
temperature range. Last digit of pump end model # indicates temperature class.
If a special temperature range was not specified, the last digit of model number will be 1.
Class 0 32 °F to 54 °F 0 °C to 12 °C
Class 1 46 °F to 72 °F 8 °C to 22 °C (Class 1 is the standard class)
Class 2 64 °F to 90 °F 18 °C to 32 °C
Class 3 82 °F to 108 °F 28 °C to 42 °C
Class 4 100 °F to 126 °F 38 °C to 52 °C
System and Components13.1 Installation13.2