Lorex LNR400 SERIES User Manual

Connecting a PTZ Camera (LNR400 Series)
20
5. Click Add Preset.
6. Repeat steps 4 and 5 to add additional presets to the tour.
Note
Click Del Tour to clear all presets from a tour.
To run a tour:
• Under No., select the number of the tour you would like to go to and click
.
20.2.3 Pattern
Patterns automatically cycle the camera between two positions.
To create a pattern:
1. Click
to open the aux menu.
2. Click the Pattern tab.
3. Under Pattern, enter the pattern you would like to configure.
4. Move the camera into the desired start position and click Begin.
5. Move the camera into the desired end position and click End.
To run a pattern:
• Under No., select the number of the pattern you would like to go to and click
.
20.2.4 Auto Scan
An auto scan automatically cycles between a left and right point.
To create a new auto scan:
1. Click
to open the aux menu.
2. Click the Border tab.
3. Move the camera into the desired left position and click Left.
#LX400021; r. 1.0/16017/16020; en-US
168

Lorex LNR400 SERIES Specifications

General

Brand	Lorex
Model	LNR400 SERIES
Category	DVR
Language	English