Rear Panel (LNR400 Series)
5
1. Power input: Connect the included AC power cable.
2. On / Off switch: Turns the NVR on or off.
3. PoE Ports: Connect IP cameras. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
4. RS232: Service only; not supported.
5. VGA: Connect a VGA monitor (not included) to view the system interface.
6. Audio IN/Audio OUT: Service only; not supported.
7. USB port(s): Connect a USB mouse (included) or USB thumb drive (not included) for
data backup or firmware updates.
8. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
9. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
10. Alarm block: Connect alarm/sensor devices (not included).
#LX400021; r. 1.0/16017/16020; en-US
8
To Next Page
Loading...
