Maintenance
Preventive maintenance
The unit does not contain any field serviceable components.
Therefore, the operator is required to perform only a very limited
amount of preventative maintenance.
It is recommended that you always fit the protective sun cover
when the unit is not in use.
Ú
Note: The protective sun cover is an accessory (sold separately).
Refer to the Installation guide provided with your unit.
Cleaning the display unit
To clean the screen:
• A micro-fiber or a soft cotton cloth should be used to clean the
screen. Use plenty of water to dissolve and take away salt
remains. Crystallized salt, sand, dirt, etc. can scratch the protective
coating if using a damp cloth. Use a light fresh water spray then
wipe the unit dry with a micro-fiber or a soft cotton cloth. Do not
apply pressure with the cloth.
To clean the housing:
• Use warm water with a dash of liquid dish soap or detergent.
Avoid using abrasive cleaning products or products containing
solvents (acetone, mineral turpentine, etc.), acid, ammonia, or
alcohol as they can damage the display and plastic housing.
Do not use a jet or high pressure wash. Do not run your unit
through a car wash.
Checking the connectors
The connectors should be checked by visual inspection only.
Push the connector plugs into the connector. If the connector plugs
are equipped with a position key, ensure that it is in the correct
position.
10
Maintenance | Hook² X Series Operator Manual
To Previous Page
Loading...
Need help?
General
