EasyManuals Logo

Lowrance StructureScan 3D Installation Manual

Lowrance StructureScan 3D
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Preface
Warning: It is your sole responsibility to install and
use the instrument and transducer(s) in a manner that
will not cause accidents, personal injury or property
damage. Always observe safe boating practices.
Sonar performance: The accuracy of the sonar depth display can
be affected by many factors, including the type and location of the
transducer and water conditions. Never use this instrument to
gauge depth or other conditions for swimming or diving.
The choice, location, and installation of transducers and other
components of the system are critical to the performance of the
system as intended. If in doubt, consult your Navico dealer.
To reduce the risk of misusing or misinterpreting this instrument,
you must read and understand all aspects of the Installation and
Operation manuals. We also recommend that you practice all
operations using the built-in simulator before using this instrument
on the water.
Disclaimer: Navico Holding AS and its subsidiaries, branches and
affiliates disclaim all liability for any use of this product in a way that
may cause accidents, damage or that may violate the law.
Compliance Statements: The StructureScan 3D Transducer
complies with:
CE under EMC directive 2014/30/EU
The requirements of level 2 devices of the Radiocommunications
(Electromagnetic Compatibility) standard 2008
The relevant Declaration of Conformity is available at the following
websites under the StructureScan 3D Transducer documentation
section:
http://www.lowrance.com/
http://www.simrad-yachting.com/
Trademarks: Lowrance
®
and Navico
®
are registered trademarks of
Navico. Simrad
®
is used by license from Kongsberg.
This manual refers to the following Navico products: DownScan
Imaging™ (DownScan), DownScan Overlay™ (DownScan Overlay),
1
2
Preface | StructureScan 3D Transducer

Other manuals for Lowrance StructureScan 3D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lowrance StructureScan 3D and is the answer not in the manual?

Lowrance StructureScan 3D Specifications

General IconGeneral
Frequency455 kHz, 800 kHz
Beam Width60° at 455 kHz, 45° at 800 kHz
Transducer TypeSkimmer
Mounting OptionsTransom mount
Max Depth300 ft (91 m)
Connector9 Pin
Cable Length20 feet
Maximum Range Side600 feet
Depth Capability300 ft (91 m)
CompatibilityHDS Gen3, HDS Carbon, HDS LIVE

Related product manuals