Lowrance StructureScan 3D Installation Manual

StructureScan 3D Transducer mounting options
"Transom mount (Transom
bracket)" on page 9
• Keeps transducer in the water when the
boat is on plane, allowing you to track
bottom at high speeds
• Transducer angle can be adjusted so it is
parallel with the water
• Transducer more likely to collide with
obstructions in the water and adds drag
to the boat
"Jackplate mount (Transom
bracket)" on page 10
• Transducer is not in the water when boat
is on plane; protects transducer and
prevents drag from transducer
• Transducer angle can be adjusted so it is
parallel with the water
• Allows you to mount transducer without
drilling holes in your boat
• Sonar does not track bottom when
transducer comes out of the water
"Step mount (Transom
bracket)" on page 12
• Transducer is not in the water when boat
is on plane; protects transducer and
prevents drag from transducer
• Transducer angle can be adjusted so it is
parallel with the water
• Sonar does not track bottom when
transducer comes out of the water
"Direct Step mount (Flush
bracket)" on page 13
• Transducer is not in the water when boat
is on plane; protects transducer and
prevents drag from transducer
• Transducer angle cannot be adjusted so
it is parallel with the water
• Sonar does not track bottom when
transducer comes out of the water
Transom mount bracket assembly
The transom mount bracket assembly comes with four washers, two
bolts and two nuts.
6
Installation | StructureScan 3D Transducer

Lowrance StructureScan 3D Specifications

General

Frequency	455 kHz, 800 kHz
Beam Width	60° at 455 kHz, 45° at 800 kHz
Transducer Type	Skimmer
Mounting Options	Transom mount
Max Depth	300 ft (91 m)
Connector	9 Pin
Cable Length	20 feet
Maximum Range Side	600 feet
Depth Capability	300 ft (91 m)
Compatibility	HDS Gen3, HDS Carbon, HDS LIVE