Page | 12
2-6. Turning on Power
Please connect the power cord to the back panel of the LPT-3000 Spectrum Analyzer
before use, and then press the “On” button on the front panel. Allow the unit to warm up
for approximately 20 minutes before operating.
If you intend to use an external signal of 10 MHz as a standard frequency, please use the 10 MHz REF
IN input connector on the rear panel.
The signal level should be over -5 dBm.
To prevent short-circuits due to condensation make sure the spectrum
analyzer is fully dry before using it in normal conditions, after storing, or
when using it in low temperature environments for long periods of time.
In order to prevent the inner temperature of the unit from rising, there is
a cooling fan on the rear panel. Please leave at least 10 cm between the
back panel and walls or other nearby devices in order to allow proper air
circulation.
To Next Page
Loading...
