Page | 54
conversion between Pause and Resume.
MEAS CONTROL >> Resume
5-10. Meas Setup
This indicates the measurement set-up menu. The indicated set-up menu varies based on the
selected measurement (ACP, Channel Power, Occupied BW, etc.) on the measure menu.
■
ACP Meas Setup
This sets the adjacent channel power measurement function.
▪ Avg Number On Off
In order to designate the average measurement number, please press Avg
Number (On). When each sweep is over, the average value will appear.
MEAS SETUP >> Avg Number
▪ Ch Integ BW
This designates the scope used in calculating the power on the center channel.
MEAS SETUP >> Ch Integ BW
▪ Offset BW
This designates the scope used in calculating the adjacent channel power.
MEAS SETUP >> Offset >> Offset BW
▪ Offset Freq
This designates the difference between the center frequency of the center
channel, and the center frequency of the adjacent channel.
MEAS SETUP >> Offset >> Offset Freq
■
Channel Power Meas Setup
This sets the channel power measurement function.
To Next Page
Loading...
