Page | 60
■
Continuous Pk On Off
When this is ON, the marker is located on the highest level of trace, and when the
sweep is over, it successively detects the highest level, and locates the marker.
PEAK SEARCH >> Continuous Pk
■
Mkr → CF
This sets the center frequency of the analyzer as the marker frequency. On delta mode,
Mkr → CF sets the center frequency as the marker delta value. Mkr → CF cannot be
used when it is on zero span.
PEAK SEARCH >> Mkr → CF
5-17. Single Sweep
When the analyzer is in continuous sweep mode, this converts to a single sweep. When the
analyzer is already on single sweep mode, it performs a new sweep once if the trigger meets the
conditions.
■
SINGLE
SWEEP >> Sweep
5-18. SPAN
This activates the span function, and makes it possible to change the span.
■
Full Span
This sets the span as the entire frequency scope of the analyzer.
SPAN >> Full Span
■
Zero Span
This changes the frequency span to 0.
To Next Page
Loading...
