Page | 56
5-11. MEASURE
This performs diverse measurement functions including the Adjacent Channel Power,
Channel Power, and Occupied Bandwidth
■
Meas Off
This turns off the measurement function.
MEASURE >> Meas Off
■
ACP
This calculates the power in the center and adjacent channel of a signal. A marker
point can be established as a measurement set-up menu while ACP is selected.
If you press Meas Setup while ACP is selected, you can set the adjacent channel
power measurement parameter. If you press Meas Control when ACP is selected,
the measurement can be temporarily suspended or resumed or makes conversion
between continuous or single modes.
MEASURE >> ACP
■
Channel Power
This calculates power and power spectrum density on a channel bandwidth
designated by a user. A marker on the display indicates the end of the channel
bandwidth. The marker selects Channel Power, and can be established as a Meas
Setup menu. It operates on single or continuous sweep mode.
If you press Meas Set-up after selecting Channel Power, you can set the channel
power measurement parameter. If you press Meas Control after selecting Channel
Power, you can temporarily suspend or resume measurement or make conversion
between continuous or single sweep modes.
MEASURE >> Channel Pwr
■
Occupied BW
The basic value of measurement is 99% of occupied bandwidth power. The
measurement operates on single or continuous sweep mode.
To Next Page
Loading...
