Page | 55
▪ Avg Number On Off
In order to designate the average number, please press Avg Number (On). The
average value will appear when each sweep is over. Avg Number
(
Off
)
inactivates
the average measurement.
MEAS SETUP >> Avg Number
▪ Integ BW
This sets the scope for making calculations of channel power.
MEAS SETUP >> Integ BW
▪ Chan pwr span
This sets the span of the analyzer for channel power measurement.
■
Occupied BW Meas Setup
This sets the occupied bandwidth measurement function.
▪ Avg Number On Off
In order to designate the average number, please press Avg Number (On). The
average value will appear when each sweep is over. Avg Number (Off) inactivates
the average measurement.
MEAS SETUP >> Avg Number
▪ OBW span
This sets the span of the analyzer for the occupied bandwidth measurement.
MEAS SETUP >> OBW Span
▪ Occ BW % Pwr
This changes the ratio of signal power used for determining the occupied
bandwidth.
MEAS SETUP >> Occ BW % Pwr
To Next Page
Loading...
