Page | 15
The MARKER key activates the marker function.
The PEAK SEARCH key activates the peak search functions.
MARKER → Sets the marker value as a specific parameter.
5.
CONTROL functions.
Allows access to menus that control the spectrum analyzer display and other
functions necessary for measurement.
The I/O DETECT key is for setting the input and output of a Ref. 10 MHz signal, and
Detect Mode.
The TRACE key is related to the set-up of trace on an LCD screen.
The AUTOSET key searches for the highest amplitude signal and automatically sets
the parameters.
The BW/AVG key is for setting functions including RBW, VBW, and AVG.
The DISPLAY key is for setting the functions of the screen.
The TRIG key is for setting the trigger function.
The SINGLE key is for performing a single sweep.
The SWEEP key is for setting a sweep time and sweep mode.
6.
MEASURE functions.
Allows the user to set up, control, and reset the spectrum analyzer’s measurement
functions and use the built-in compliance masks.
The MEASURE key allows access to measurement tools and compliance masks.
The MEAS CONTROL key is for controlling measurement functions.
The MEAS SETUP key is for setting measurement functions.
The RESTART key is for resetting measurements.
7.
The function within the SYSTEM key affects the entire state of the analyzer.
Diverse set-ups and arrangements can be made by using the SYSTEM key.
The PRESET (reset) key will reset the analyzer to its factory default state.
The FILE key menu makes it possible to save the current trace state in the
memory of the analyzer or the USB flash memory, or allow loading from them.
The SAVE key immediately performs the currently selected save function.
The PRINT SETUP menu key allows you to select printing options.
The PRINT key immediately sends selected/current data to a connected printer.
To Next Page
Loading...
