Page | 62
allows the analyzer to revert to the most recent state it was in when it was
powered down. You must use the Power on/Preset menu key to change the
preset state that is loaded upon powering on the analyzer.
▪ Preset Type Factory User
If you press Preset (Factory), the analyzer resets to factory defaults upon
startup. If you press Preset (User), you can setup the analyzer as saved by the
Save User Preset key. (Please refer to Preset in this chapter.)
Save User Preset
When you press Save User Preset, the current state of the analyzer is saved on
the User Preset register.
■
Time/Date
Provides a menu allowing you to change time and date.
▪ Time/Date
This turns on and off the time and date.
SYSTEM >> Time/Date >> Time/Date
▪ Date Format
This changes the display type of a date from MM-DD-YY to DD-MM-YY.
SYSTEM >> Time/Date >> Date Format
▪ Set Time
This sets the time. Please enter the time in a 24 hrs HHMMSS format by using
the numeric keypad, then press Enter. The effective time values
(
HH
)
are 00 ~
23. The effective MM and SS values are 00 ~ 59.
SYSTEM >> Time/Date >> Set Time
▪ Set Date
This allows you to set the date. Please enter a date in YYYYMMDD format by
using the numeric keypad, than press Enter. The effective YYYYs are from 2000
to 2037. The effective MM value is 01 ~ 12, and the DD is 01 ~ 31. Use the
To Next Page
Loading...
