pg. 15
Controls markers, reads frequency and amplitude on the trace and automatically
detects the signal with the highest amplitude.
MARKER key activates the marker function.
PEAK SEARCH key activates the peak search functions.
MARKER ā Sets the marker value as a specific parameter.
5.
CONTROL functions.
Allows access to menus that control the spectrum analyzer display and other
functions necessary for measurement.
I/O DETECT key is for setting the input and output of a Ref. 10 MHz signal, and
Detect Mode.
TRACE key is related to the set-up of trace on an LCD screen.
AUTOSET key searches and for the highest amplitude signal and automatically set
the parameters.
BW/AVG key is for setting functions including RBW, VBW, and AVG.
DISPLAY key is for setting the screen indicating functions.
TRIG key is for setting the trigger function.
SINGLE key is for performing a single sweep.
SWEEP key is for setting a sweep time and sweep mode.
6.
MEASURE functions.
Allows the user to set up, control and reset the spectrum analyzer measurements
functions and use the built-in compliance masks.
MEASURE key allows access to measurement tools and compliance masks.
MEAS CONTROL is for controlling measurement functions.
MEAS SETUP key is for setting measurement functions.
RESTART key is for resetting measurements.
7.
The function within a SYSTEM key, affects the entire state of the analyzer. You can
make diverse set-up and arrangement by using this SYSTEM key.
PRESET key is initializing the analyzer to an established state.
FILE key menu makes it possible to save the current trace state in a memory of the
analyzer or USB flash memory, or make it to be loaded from them.
SAVE key immediately perform the currently defined saving function.
PRINT SETUP menu key makes it possible to set printing stuffs.
To Next Page
Loading...
