pg. 46
▪ Trace
Trace can be loaded along with the analyzer state when saved. If you load Trace,
it will be in View mode. If you load Trace, it will go to Trace 1 except for Trace
All returning to a location of the state that each trace is saved. Trace + State
type only can be loaded.
■
Delete
It deletes a file as a memory of the analyzer.
■
Copy
It copies a file on other directories of the internal analyzer or USB flash memory.
■
Rename
It changes a file name.
■
Create Dir
It creates a new directory on the internal memory of the analyzer.
5-5. FREQUENCY
It activates the center frequency set-up function, and displays the menu of the frequency function.
Frequency values are show below each specific function soft key menu. It is not recommended to
enter frequencies larger than the frequency span of the spectrum analyzer.
■
Center Freq
It sets the Center Frequency using the step keys, scroll knob and numeric key pad.
FREQUENCY >> Center Freq
■
Start Freq
It sets the start frequency. The left and right of the lattice conform to the start and
stop frequencies. When this function is activated, the Start Frequency and Stop
Frequency will be indicated on a location indicating the center frequency under the
lattice and a span. The Start Frequency can be changed by using the step keys, scroll
To Next Page
Loading...
Need help?
General
