pg. 63
the function of turning on power is established as Preset, the state of the
analyzer becomes the same of pressing Preset while the analyzer is turned on.
When the function of turning on power is established as Last, the state of the
analyzer will be restored to the previous state where the power was still on.
Although you press Preset, the set-up (Last or Preset) of the function of turning
on power is not changed, To change the set-up of the state of the analyzer
restored when inputting power, please use the Power On/Preset menu key.
▪ Preset Type Factory User
If you press Preset (Factory), it becomes initialized in accordance with the
composition of the original state of the analyzer, which was established in
delivery. If you press Preset (User), you can set the analyzer as saved by the
Save User Preset key. Also, if you press Preset (Factory) and Preset (User), the
initialization of the device gets started. (Please refer to the Preset in this
chapter.)
Save User Preset
When you press Save User Preset, the current state of the analyzer is saved on
the User Preset register.
■
Time/Date
There appears a menu that you can change time and date.
▪ Time/Date
It turns on and off the time and date.
SYSTEM >> Time/Date >> Time/Date
▪ Date Format
It changes the display type of a date from MM-DD-YY to DD-MM-YY.
SYSTEM >> Time/Date >> Date Format
▪ Set Time
It sets the time. Please enter the time in a 24 hrs HHMMSS format by using the
To Next Page
Loading...
Need help?
General
