(9) HST neutral switch (HST type)
It is located under the HST pedal, and the switch
can only be pressed while the pedal is at neutral.
If this switch is not pressed, the engine can not
start.
This is a start safety switch to prevent the sudden
starting of the tractor when engine starts.
Do not arbitrarily remove the switch. It may cause the accident.
Do not arbitrarily remove the switch. It may cause the accident.
▶
When the engine does NOT start or neutral set of the HST pedal is adjusted, check
the switch is pressed when the HST pedal is in neutral position
warning
(10) Cruise control lever
(HST Type)
For cruise drive, lift the cruise control lever up in
the state of pressing the HST pedal forward. And
then, the HST pedal shall be fixed and the tractor
can drive forward with constant speed.
To quit the cruise drive ;
1) Press the brake pedal down or
2) Press the HST pedal forward little more.
And then, The HST pedal returns to the neutral
position and the cruise drive shall be quitted.
Cruise control lever
Cruise drive
Release
3
3 3
3 - 11
position and the cruise drive shall be quitted.
▶
During the cruise drive, pressing the HST pedal backward to release the cruise
drive or to reverse the tractor is NOT available. After quitting the cruise drive as
above described, press the HST pedal backward.
▶
DO NOT try to move the cruise control lever down to quit the cruise drive. It may
cause the failure of the cruise control linkage system.
warning
To Next Page
Loading...
Need help?
General
